Bolt Circle PCD Calculator
Find the pitch circle diameter (PCD) of a hole pattern with no drawing: measure across two holes with a caliper, enter the hole count and read off the PCD, with the nominal size it most likely was. Free, no login.
Know the PCD already and need the hole positions? Use the Metric Bolt Circle Layout.
Likely nominal PCD
Measure two or three pairs of holes and use the average. A single worn or badly drilled hole moves the answer.
How to measure it
A chord is a straight line between two points on a circle. The centre distance between two holes is a chord of the pitch circle, and with the hole count it fixes the PCD.
Caliper trick: measure the hole Ø, press zero on the caliper, then measure over the outside edges of the two holes. The display now reads the centre distance directly (outside over the holes minus hole Ø).
- Centres
- Centre-to-centre distance between the two holes. This is the chord.
- Outside edges
- Outside jaws over the far edges of both holes. Chord = reading − hole Ø.
- Inside edges
- Inside jaws between the near edges of both holes. Chord = reading + hole Ø.
- PCD
- PCD = chord ÷ sin(180° × holes apart ÷ number of holes).
- Holes apart
- 1 for neighbouring holes. On an even hole count, measuring straight across (number of holes ÷ 2) gives the PCD directly and has the smallest error.
- Accuracy
- A caliper error on the chord grows by 1 ÷ sin(180° × holes apart ÷ number of holes) on the PCD. On 8 holes measured across neighbours it is 2.6 times; straight across it is 1 times.
- Nominal
- Patterns are drawn to round sizes: whole or half millimetres, inch fractions (101.6 mm is 4 in), or a standard wheel PCD such as 5 × 114.3. Sizes inside the caliper band are marked.
Common questions
How do I measure a PCD with a caliper?
Measure the centre distance between two holes. Easiest: measure over the outside edges of both holes and subtract one hole diameter, or measure between the inside edges and add one hole diameter. That centre distance is a chord of the pitch circle.
What is the formula for PCD from the hole spacing?
PCD = chord ÷ sin(180° × holes apart ÷ number of holes). Five holes with 67.2 mm between neighbouring centres: 67.2 ÷ sin(36°) = 114.33 mm, so most likely a 5 × 114.3 pattern.
How do I measure the PCD of a 5-hole pattern?
An odd hole count has no hole straight across, so measure between neighbours, or two holes apart for a smaller error. On an even hole count, measure straight across: that reading is the PCD.
How accurate is the result?
A caliper error on the chord grows by 1 ÷ sin(180° × holes apart ÷ number of holes). On 8 holes measured across neighbours it is 2.6 times; straight across it is 1 times. Measure two or three pairs and use the average.
What size was the pattern drawn to?
Patterns are drawn to round sizes: whole or half millimetres, inch fractions (101.6 mm is 4 in) or a standard wheel PCD such as 5 × 114.3. The calculator lists the nominal sizes inside the measuring error band.